Califone Mouse LP 1 User Manual

LP-1  
Laser Pointer  
Wireless Presentation  
Trackball Mouse  
Owner’s Manual  
califone.com  
 
Specifications/Features  
• Transmission Frequency: 2.4GHz  
• Trackball mouse  
• Laser pointer function  
• Sleeping mode current: 22uA  
• Usage time: 40-45 days (average usage, full charge)  
• Charging time: 6-8 hours  
• Operating range: 30(from receiver)  
• 4 buttons (2 mouse buttons + 2 fwd/back buttons)  
• Lanyard on pointer/mouse for wearing around neck  
• 28retractable USB cable for recharging  
• Case Material: Rubberized ABS  
• Supply voltage: 3V (batteries) / 5VDC (USB)  
• Regulatory: CE, FCC  
• Dimensions (pointer): 1.25x 2x 4”  
• Weight: 53.2g (pointer w/o batteries) + 5g (receiver)  
• Max operating current: 22mA  
System Compatibility  
Windows XP/95/98/ME/2000/NT4.0 (on older operating systems, USB drivers must be pre-installed)  
Setup & Operation:  
1. Put the batteries into the laser pointer and connect the laser pointer to your computer using the provided USB cable.  
The laser pointer should automatically charge the batteries. Please allow 8 hours charging time before using the pointer.  
2. After charging, you may disconnect the pointer from the computer. Then plug the USB receiver into your computer.  
3. After a short period of time (~1minute) your computer should automatically recognize the new device and it  
should be ready to operate.  
4. The pointer/mouse has a three-position switch. The left position isOff. The middle positionPointeris to operate the  
laser pointer only (the mouse will not function in this mode). The right positionMouseenables all of the functions  
(mouse, buttons, laser pointer).  
5. The mouse should work out-of-the-box, but if the mouse and button functions do not operate, you may need to match  
the mouse/pointer to the USB receiver. To do so, follow these steps:  
• Make sure the receiver is connected to the PC and is recognized properly by your computer.  
• Press the button on the receiver. The LED on the receiver should begin to flash  
• Then, on the mouse move the switch to the middle or right, position and click the Code Matching  
button at the back of the unit.  
• When the LED on the receiver stops flashing, the units should be properly set up.  
When in Pointer mode and Microsoft Powerpoint is the active application on the  
computer, the buttons function as follows:  
• Previous Slide (lower left button)  
• Next Slide (lower right button)  
• Pause Presentation (go to blank screen momentarily ; press again to go back to presentation) ( upper left button)  
• Exit Presentation (double click to exit) ( upper right button)  
When in Mouse mode, the buttons function as follows:  
• Mouse Left Click (lower left button)  
• Mouse Right Click (lower right button)  
• Backward (upper left button) – Can be used in applications and Windows folders.  
• Forward (upper right button) – Can be used in applications and Windows folders.  
2
 
CAUTION  
RISK OF ELECTRIC SHOCK - DO NOT OPEN  
!
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER OR  
BACK. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QAULIFIED  
PERSONNEL.  
The exclamation point within a  
The lightening flash with arrowhead  
triangle is intended to tell the user  
within a triangle is intended to tell the  
that important operating and servicing  
user that parts inside the product are a  
risk of electric shock to persons.  
instructions are in the papers with  
!
the appliance.  
This product is not designed to  
function normally in strong electro-  
magnetic fields. Consequently, the  
Ce produit n’est pas conçu pour  
un fonctionnement dans de forts  
champs électromagnétiques. Par  
conséquent, la qualité sonore peut  
diminuer si ce produit est exposé à  
WARNING:  
TO REDUCE THE RISK OF  
FIRE OR ELECTRIC SHOCK, SO  
NOT EXPOSE THIS APPLIANCE  
TO RAIN OR MOISTURE.  
audio quality may degrade while the  
product is exposed to strong electromagnetic fields.  
Normal audio quality operation will be recovered  
when the strong electromagnetic field is no  
longer present.  
un fort champ életromagnétique. La qualité sonore  
redeviendra normale après affaib-lissement du  
champ électromagnétique.  
IMPORTANT SAFETY INSTRUCTIONS  
POWER CORD PROTECTION - POWER SUPPLY CORDS  
ATTENTION: ALL SAFETY AND OPERATING INSTRUCTIONS  
SHOULD BE READ BEFORE OPERATING APPLIANCE. ALL OPER-  
ATING AND USE INSTRUCTIONS SHOULD BE FOLLOW-  
ED WHEN OPERATING THE APPLIANCE. HEED AND ADHERE  
TO ALL WARNINGS ON THE APPLIANCE AND IN THE OPERATING  
INSTRUCTIONS. RETAIN ALL SAFETY AND OPERATING INSTRUC-  
TIONS FOR FUTURE REFERENCE.  
SHOULD BE ROUTED SO THAT THEY ARE NOT LIKELY TO BE  
WALKED ON OR PINCHED BY ITEMS PLACED UPON OR AGAINST  
THEM, PAYING PARTICULAR ATTENTION TO CORDS  
AT PLUGS, CONVENIENCE RECEPTACLES, AND THE POINT WHERE  
THEY EXIT FROM THE APPLIANCE.  
CLEANING - THE APPLIANCE SHOULD BE CLEANED ONLY AS REC-  
OMMENDED BY THE MANUFACTURER.  
WATER & MOISTURE - DO NOT USE THE APPLIANCE NEAR  
WATER; IE. BATHTUB, WASHBOWL, KITCHEN SINK, LAUNDRY  
TUB, WET BASEMENT OR SWIMMING POOL.  
NON USE PERIODS - UNPLUG THE APPLIANCE POWER CORD  
FROM THE OUTLET WHEN LEFT UNUSED FOR A LONG PERIOD OF  
TIME.  
VENTILATION - DO NOT SITUATE THE APPLIANCE SO THAT  
ITS LOCATION OR POSITION INTERFERES WITH ITS PROPER  
VENTILATION. FOR EXAMPLE, THE APPLIANCE SHOULD NOT  
BE SITUATED ON A BED, SOFA, RUG OR SIMILAR SURFACE THAT  
MAY BLOCK THE VENTILATION OPENINGS. THE  
OBJECT & LIQUID ENTRY - CARE SHOULD BE TAKEN SO THAT  
OBJECTS DO NOT FALL AND LIQUIDS ARE NOT SPILLED INTO THE  
ENCLOSURE THROUGH OPENINGS.  
APPLIANCE SHOULD NOT BE PLACED IN A BUILT-IN  
INSTALLATION, SUCH AS A BOOKCASE OR CABINET, THAT  
MAY IMPEDE THE FLOW OF AIR THROUGH THE VENTILATION  
OPENINGS.  
DAMAGE REQUIRING SERVICE - THE APPLIANCE SHOULD BE SER-  
VICED BY QUALIFIED SERVICE PERSONNEL WHEN: (A) THE POWER  
SUPPLY CORD OR THE PLUG HAS BEEN DAMAGED (B) OBJECTS  
HAVE FALLEN OR LIQUID HAS BEEN SPILLED INTO THE APPLIANCE  
(C) THE APPLIANCE HAS BEEN EXPOSED TO RAIN (D) THE APPLI-  
ANCE DOES NOT APPEAR TO BE OPERATING NORMALLY OR EXHIB-  
ITS A MARKED CHANGE IN PERFORMANCE (E) THE APPLIANCE HAS  
BEEN DROPPED OR THE ENCLOSURE DAMAGED.  
HEAT - SITUATE THE APPLIANCE AWAY FROM HEAT SOURCES  
SUCH AS RADIATORS, HEAT REGISTERS, STOVES OR OTHER AP-  
PLIANCES (INCLUDING AMPLIFIERS) THAT PRODUCE HEAT.  
POWER SOURCES - CONNECT THE APPLIANCE ONLY TO A  
POWER SUPPLY TYPE DESCRIBED IN THE OPERATING INSTR-UC-  
TIONS OR MARKED ON THE APPLIANCE.  
SERVICING - THE USER SHOULD NOT ATTEMPT TO  
SERVICE THE APPLIANCE BEYOND THAT DESCRIBED IN  
THE OPERATING INSTRUCTIONS. ALL OTHER SERVICING REFER TO  
A QUALIFIED SERVICE PERSONNEL.  
GROUNDING OR POLARIZATION - PRECAUTIONS SHOULD BE  
TAKEN SO THAT THE GROUNDING OR POLARIZATION MEANS OF  
THE APPLIANCE ARE NOT DEFEATED.  
Califone® International Inc. • 1145 Arroyo Avenue, # A • San Fernando, CA 91340 USA  
Toll Free 800.722.0500 | Toll Free Fax 877.402.2248  
International Customers call 818.407.2400 or Fax 818.407.2405 califone.com  
 
August 2007  

Belkin Network Card F5L014 User Manual
Black Decker Drill DR220G User Manual
Blaupunkt Car Stereo System Arizona DJ70 User Manual
Blount Chainsaw 633GC User Manual
Bosch Power Tools Laser Level GLL2 80 User Manual
Breville Fryer BDF300 User Manual
Briggs Stratton Lawn Mower 5021029 User Manual
Briggs Stratton Pressure Washer 20362 User Manual
CDA Cooktop HCN610 User Manual
Chief Manufacturing Indoor Furnishings FSR Series User Manual